Above are some different versions of my toothbrush holder that I created. While creating it I started of simple, creating a sketch of a rectangle. However, after extruding it, I was confronted with my first problem: dividing the inside of the rectangle. I thought I could simply make a sketch on top of the face that was going to make hollow, and just divide the face, but when it came to shelling it, it would only let me choose the whole face, not just the part that I divided. I tried creating a separate rectangle sketch on the face, but it still wouldn’t let me shell that rectangle either. So, I started all over and decided to do two separate rectangles, one smaller than the other. I had to do a little bit of math here because I had to get both parts to equal the total length I wanted, and some of the measurements had to be equal. Once I created the separate rectangle sketches, I was able to extrude them and shell both of them. I had two bodies, but I wanted to only have one with the divided section. So, all I had to do was get the bodies close to each as if they were connected, align them, and make sure the height and width were the same. Once I did those things, I combined them. When I did that, I noticed it was pretty simple, so I decided to add a bit of extra things to make it look decorated. For this, I kept making rectangle sketches around the rim of the object, as well as at the bottom, and extrude them. As you can see at the bottom of this paragraph, I had many sketches.

Once I rendered it, I noticed it was missing something, an actual toothbrush. Now I know I couldn’t get the actual texture of the toothbrush, but I could have at least made an attempt at at something that will look like it. On the bottom are some pictures of my toothbrush holder and my toothbrush. I added a bit of customization by putting my face on the object as well.

Now this picture is my 3D model actually being put into use. I used photoshop to make it look like it was actually placed where it was suppose to be.

Before 
After
Above are all the measurements for my toothbrush holder. Every width, length, and height is in mm in the pictures above, height being 111mm, total width being 75.9mm and length being 147.04mm. Other measurements are also above for the extra add ons and the insides.


















